• Hello there guest and Welcome to Fox Body Mustangs forum, This forum is intended to be used by enthusiasts of the Fox body Ford Mustangs (1979-1993)!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

351w build help!!!

Ohh sweet, have u tryed it out yet? And i was looking at those and was rather goona get the lunaties or the morel


Sent from my iPhone using Tapatalk
 
spady said:
Ohh sweet, have u tryed it out yet? And i was looking at those and was rather goona get the lunaties or the morel


Sent from my iPhone using Tapatalk
Click to expand...
Motor just got finished so it will be going in the car in the next week or two. :)


Sent from my iPhone using Tapatalk
 
Nice! I cant wait to be at that point[emoji4] what ur power goal with it?


Sent from my iPhone using Tapatalk
 
spady said:
Nice! I cant wait to be at that point[emoji4] what ur power goal with it?


Sent from my iPhone using Tapatalk
Click to expand...
I don't really care about numbers but I'm guessing it will be 620-650 at the crank, run mid-low 10s in the quarter. 408w, Victor jrs, super vic, custom cam from Ed and Alky injection. :)


Sent from my iPhone using Tapatalk
 
Man 408w strokers are bad ass! That should be killer! And true, its all about the ET!


Sent from my iPhone using Tapatalk
 
I would not deck the block other than a clean up / truing pass. rather go with cometic .027 thick mls head gaskets along with hyper kb pistons
 
interested in a barely used set of 351 W push rods > they have about 175 miles on them - 8.144" - dirt cheap. they have been stored for about 27 years.
 
You must log in or register to reply here.
Back
Top