• Hello there guest and Welcome to Fox Body Mustangs forum, This forum is intended to be used by enthusiasts of the Fox body Ford Mustangs (1979-1993)!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

351w build help!!!

spady

Member
Ohh sweet, have u tryed it out yet? And i was looking at those and was rather goona get the lunaties or the morel


Sent from my iPhone using Tapatalk
 

Blown347

Moderator
Staff member
Ohh sweet, have u tryed it out yet? And i was looking at those and was rather goona get the lunaties or the morel


Sent from my iPhone using Tapatalk
Motor just got finished so it will be going in the car in the next week or two. :)


Sent from my iPhone using Tapatalk
 

spady

Member
Nice! I cant wait to be at that point[emoji4] what ur power goal with it?


Sent from my iPhone using Tapatalk
 

Blown347

Moderator
Staff member
Nice! I cant wait to be at that point[emoji4] what ur power goal with it?


Sent from my iPhone using Tapatalk
I don't really care about numbers but I'm guessing it will be 620-650 at the crank, run mid-low 10s in the quarter. 408w, Victor jrs, super vic, custom cam from Ed and Alky injection. :)


Sent from my iPhone using Tapatalk
 

spady

Member
Man 408w strokers are bad ass! That should be killer! And true, its all about the ET!


Sent from my iPhone using Tapatalk
 

ROBERT COWAN

New Member
I would not deck the block other than a clean up / truing pass. rather go with cometic .027 thick mls head gaskets along with hyper kb pistons
 

fastronald

New Member
interested in a barely used set of 351 W push rods > they have about 175 miles on them - 8.144" - dirt cheap. they have been stored for about 27 years.
 
Top