Single outlet line lock

[Stephen Spangler]

I traded for a BandM line lock.Upon looking it over I notice it only has one output port.Have any of you used one of these this style by placing a T to join the front brake lines and run a line into the solenoid?

 

[broncojunkie]

I've never used or installed a line lock, but I figured it would get installed between the master cylinder and the prop valve. That way, you only need the one in/out.

 

[Stephen Spangler]

I've never used or installed a line lock, but I figured it would get installed between the master cylinder and the prop valve. That way, you only need the one in/out.

 

[Stephen Spangler]

One front brake line goes to the master and one to a proportion valve.Its kinda a dumb design.Im going try to join the two and plug the master port.I will then use the line coming from the valve to feed the lock then feed the T.Thanx for your reply though.

 

[nick bruscella]

Did it come with instructions? Go to b/ m site see if you can get some. Or ask the smartass goggle he knows everything

 

[ALMOST STOCK]

Here ya go. https://documents.holley.com/46076_instructions.pdf

 

[ALMOST STOCK]

Or call for Technical Support (866) 464-6553

 

[nick bruscella]

That's what I'm talking about,good going (almost.)

 

[Stephen Spangler]

Update It worked out fine after a bought the right fittings(metric)I bought a kit from hurst with lines and fittings.It was pretty much useless(all sae fittings)Jegs sales kit just for mustangs with the proper fittings (metric to sae).You will just need a few short brake lines.This saves money going this route also.