Ok I'm back.
I'm almost ready to get engine back from machine shop.
Come to find out that engine was already bored 30 over and crank has been turned 10 thousands.
So block and is good to go.
I need some help to figure out how to find what pushrods I need and how to go about preloading my lifters so I can get an accurate measurement.
I was told I could preload all lifters by hand using a bucket with some oil and an old pushrod but still don't know how good that will work.
I do have a pushrod adjuster tool.
What I'm building is a stock 30 over block with AFR 165 heads and 1.7 crane rockers with stock cam with gt40 intake.
Could use a walk through with pushrods and the best way to preload lifters without having to put engine together and then taking back apart.
I'm almost ready to get engine back from machine shop.
Come to find out that engine was already bored 30 over and crank has been turned 10 thousands.
So block and is good to go.
I need some help to figure out how to find what pushrods I need and how to go about preloading my lifters so I can get an accurate measurement.
I was told I could preload all lifters by hand using a bucket with some oil and an old pushrod but still don't know how good that will work.
I do have a pushrod adjuster tool.
What I'm building is a stock 30 over block with AFR 165 heads and 1.7 crane rockers with stock cam with gt40 intake.
Could use a walk through with pushrods and the best way to preload lifters without having to put engine together and then taking back apart.