• Hello there guest and Welcome to Fox Body Mustangs forum, This forum is intended to be used by enthusiasts of the Fox body Ford Mustangs (1979-1993)!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

What Molding?

David Ralph

New Member
I have a 1985 SVO. What rear quarter (wheel well to bumper) molding was used from what year mustang. Same question for the rear bumper. How were these rear moldings attached. Thanks in advance.


Dave
 

83stang

Member
I think if you pull back the liner in the inner trunk there are 3-11/32 bolts on each side- deep socket needed. Then pull the carpet away from the inside trunk that hides the tail lights across the back there should be 6 more 11/32 nuts. Under the car you will have 8 larger bolts that holds the bumper to the frame then there are 6 push pins along the bottom to keep it from plopping around- this is based on my 83 but I think yours is the same.
 
Top