Recently acquired a '91 NYSP SSP. I need some sheet metal including a driver's side floor pan and rear lower quarter patch panel. There's a ton of sellers online but are they all essentially the same stamped piece or are there better panels than others? I am looking to do a high quality resto and not cheap out. Thanks and looking forward to using these forums!
-
Hello there guest and Welcome to Fox Body Mustangs forum, This forum is intended to be used by enthusiasts of the Fox body Ford Mustangs (1979-1993)!
To gain full access you must Register. Registration is free and it takes only a few moments to complete.
Already a member? Login here then!
1991 NYSP SSP-New member
- Thread starter NYSSP
- Start date
broncojunkie
Well-Known Member
I thought they made a firewall reinforcement piece for them. And I would definitely check the input shaft retainer. If it's gauled up, that will definitely make it bind.