wifes new 89 4 banger coupe

[87_notchfox]

Not the transgo one. Baumann really makes the best kit. But you can't use those on aftermarket valvebodies. The valvebody you have should be perfectly fine as is.


Sent from my iPhone using Tapatalk

well i was going to use it on her stock valve body not the lentech one.

 

[87_notchfox]

Update...trans seems to be shifting ok. But I keep getting codes 10, 29, 41, 67, 91. I know one O2 sensor might be bad. But the rest not to sure. Also went out for a ride and the car over heated. Had plenty of fluid in the radiator system is fairly new with electric fans. Not sure if the cap is bad.

 

[87_notchfox]

does anyone know how to erase the codes on obd I?

 

[Blown347]

does anyone know how to erase the codes on obd I?

1. Setup the system to run a KOEO self-test.
2. Turn Ignition On.
3. As soon as the codes start to flash, disconnect the STI jumper wire.
4. Turn Ignition Off, set the system to run a KOEO self-test again, and confirm code 15 is cleared from memory (CM codes).


Sent from my iPhone using Tapatalk

 

[87_notchfox]

1. Setup the system to run a KOEO self-test.
2. Turn Ignition On.
3. As soon as the codes start to flash, disconnect the STI jumper wire.
4. Turn Ignition Off, set the system to run a KOEO self-test again, and confirm code 15 is cleared from memory (CM codes).


Sent from my iPhone using Tapatalk

Sweet thanks. I got to figure out this code situation on the wife's car